Trailer electrical interface converts from 24 volt (Military standard) to 12 volt (civilian standard). This allows towing a civilian trailer with a Military vehicle. Input and output is 10.5 foot multiconductor cable, Tectran Articflex rated to minus 85F. Ring terminals are crimped on the cable leads.
Converter is made in USA. We are an authorized factory distributor and the product includes a 2 year manufacture's warranty.
UTC 2412GD Specifications:
Inputs: 21-29 Volts DC (will withstand 36 Volts DC)
Input current: 45 Amps max total
Number of converters per unit: 6 (5 control lights or aux functions, extra 1 with higher current rating allows for electric brakes, see i/o listing below)
Output: 13.6 Volts DC +/- 0.3 VDC
Output current capability on 5 main converters: 10 Amps.
Output current capability on 6th auxiliary converter: 15 Amps
Output power: 800 Watts max total
Overload and short circuit protection: electronically controlled
Efficiency: 90 percent typical
Aluminum housing with steel end caps.
Mounting holes (6) for 1/4 inch hardware.
Overall Length: 21-1/4 inches
Overall Height: 4-3/4 inches
Overall width: 8-11/16 inches
Sealed case protects against water and dust.
Input and output cable configuration with max rated current:
Black, 10 Amps
Brown, 15 Amps
Red, 10 Amps
Yellow, 10 Amps
Green, 10 Amps
Blue, 10 Amps
White wire is ground
Note: unit is not a trailer brake controller. Electric brakes, if used, must have their own controller installed. It can be powered by one of this unit's auxiliary converters or a separate converter such as ST-340.
To interface an electric brake controller with a military vehicle use relay interface p/n 4M-6003.
25 lb shipping weight